Standard Component Installation and Adjustment Standard Component Installation and Adjustment Standard Component Installation
and Adjustment Installing the Leg Spars Insert the proximal end of the left and right Leg Spar into the appropriate Spar Mount. A click should be heard when the Leg Spar post is inserted past the safety latch. Lock in place by turning the Spar Locking Knob clockwise until tight. Standard Component Installation
and Adjustment Removing the Leg Spars Turn the Spar Locking Knob counterclockwise to unlock the Leg Spar. Lift the safety latch to release it, allowing the Leg Spar to be removed, and slide the Leg Spar out of the Spar Mount. Standard Component Installation
and Adjustment Adjusting the Leg Spars Each Leg Spar is designed to support the patient’s foot in the Traction Boot or with skeletal traction devices and allows for traction, abduction, adduction, and raising or lowering of the leg. It also provides an attachment point for the Knee Flexion System®. 1. Boot Operation Locking Handle
2. Knee Flexion System Mounting Post
3. Gross Traction Knob
4. Foot Rotation Locking Knob
5. Internal/External Rotation Dial
6. Fine Traction Crank Handle
7. Spar Lock Handle
8. Loop Handle Radiolucent Leg Spar Controls Standard Component Installation
and Adjustment Installing and Positioning the Patient Strap Slide the Patient Safety Strap around the Foot-End of the Hana Table. Once the patient is transferred to the table, buckle the Patient Safety Strap around the patient at waist level and pull strap through the buckle until patient is secured firmly to the Hana Table. Standard Component Installation
and Adjustment Installing the Arm Boards Rotate the drop handle at the distal end of the Swing Bar counterclockwise to unlock, and move the Swing Bar out from under the table top. Insert the post of the Hana Arm Board into the slot on the Holding Clamp. Standard Component Installation
and Adjustment Traction Boots Refer to the following size chart to select the appropriate Traction Boot. Adjust the amount of padding as needed for the size of the patient’s foot. VIEW SIZING CHART Standard Component Installation
and Adjustment Small Traction Boot

US	4½	5	5½	6	6½*
UK	5½	6	6½	7	7½*
EUR	37½	38	38½	39	40*
JPN	23.5	24	24.5	25	25.5*

US	7	7½	8	8½	9*	9½**
UK	8	8½	9	9½	10	10½**
EUR	40½	41	42	42½	43	44**
JPN	26	26.5	27	27.5	28	28.5**

Large Traction Boot Extra Large Traction Boot

US	10	10½	11	11½	12
UK	11	11½	12	13	14
EUR	44½	45	46	46½	47
JPN	29	29.5	30	31	32

* Either Small or Large boots can be used depending on patient’s boot fitting. ** Either Large or Extra Large boots can be used depending on patient’s boot fitting.