1 Advanced Control Base
Preparation & Installation Advanced Control Base
Preparation & Installation Orient the Head-End Column of the Advanced Control Base (ACB) toward the anesthesiologist work station. If the ACB is retracted, unlock the Retracting Knob and pull the Head-End and Foot-End Columns in opposite directions until fully expanded. Lock the Retracting Knob. Lock the four (4) casters of the Base. Standard Component Installation and Adjustment Prior to procedure set up, refer to the Standard Component Installation and Adjustment section and complete the required steps. VIEW NOW CONTINUE WITH SETUP Plug the Power Cord of the ACB into a properly-ground receptacle. Connect the Hand Pendant to the port on the Head-End. Toggle the Power Switch to the ON position. Confirm the Rotation Safety Lock switch, the 180 Degree Rotation Lock Indicator light, and the Tilt Drive Status Indicator light are illuminated. Advanced Control Base
Preparation & Installation To install the table top, remove any H-Frames that may be attached to the crossbars if the Base was previously used with a different table top. Carefully align the table top end with the Base’s Head-End crossbar and the leg spar end with the Base’s Foot-End crossbar. Advanced Control Base
Preparation & Installation Caution: To prevent injuries, two people should install the table top. Remove a T-Pin from the Quiver and pass it completely through the crossbar and the table top mounting holes. Advanced Control Base
Preparation & Installation Ensure the Drop Lock is visible and pivots freely on the opposite side. Advanced Control Base
Preparation & Installation Unlock and rotate the table top 180 degrees. Relock the 180º Rotation Lock and the Rotation Safety Lock. Ensure the indicator lights are on. Advanced Control Base
Preparation & Installation Caution: Rotation of the table top is intended for purposes of table top installation only. DO NOT attempt to rotate the Orthopedic Trauma Top with a patient on the table.