12 Hip Arthroscopy Standard Component Installation
and Adjustment Standard Component Installation and Adjustment Prior to procedure set up, refer to the Standard Component Installation and Adjustment section and complete the required steps. VIEW NOW CONTINUE WITH SETUP 1 Optional - Jack Mount Assembly If the optional Patient Transfer Board is to be used, ensure that the Jack Mount Assembly is installed. Optional - Jack Mount Assembly If the optional Patient Transfer Board is to be used, ensure that the Jack Mount Assembly is installed. View Part 2 Radiolucent Leg Spars Attach both the left and right Radiolucent Leg Spars to the table and lock in place. Radiolucent Leg Spars Attach both the left and right Radiolucent Leg Spars to the table and lock in place. View Part 3 Pelvic Pad Place the Pelvic Pad on the table. Pelvic Pad Place the Pelvic Pad on the table. View Part 4 Patient Safety Strap Slide the Patient Safety Strap into place. 5 Optional - Patient Transfer Board Attach the optional Patient Transfer Board. Adjust the table to the appropriate height for patient transfer from the stretcher. Optional - Patient Transfer Board Attach the optional Patient Transfer Board. Adjust the table to the appropriate height for patient transfer from the stretcher. View Part 6 Traction Boots Put the appropriate size Traction Boots (small, large, or optional extra-large) on the patient’s feet while the patient is on the stretcher. Patient Instructions Patient Instructions Transfer the patient to the table in the supine position and secure with the Patient Safety Strap. 7 Large Diameter Perineal Post Insert the Large Diameter Perineal Post. Move the patient to establish firm contact with the Perineal Post and secure with the Patient Safety Strap. 8 Traction Boots and Leg Spars Attach the Traction Boots to the Leg Spar Traction Mounts and lock in place. Patient Instructions Patient Instructions If the patient is short in stature and the Traction Brake Cover enters the Red Zone, the installation and use of the Traction Hook Extenders are required. 9 Arm Boards Install an Arm Board with pad to both right and left sides of the table and position the patient’s arms out to the side, or attach one Arm Board with pad and the optional Cross Arm Support using a Clark Socket to the non-operative side of the table. Secure the patient’s arms. 10 Optional - Patient Transfer Board Remove the optional Hana Patient Transfer Board by sliding it out from underneath the fully positioned patient. 11 Optional - Leg Support Attach the optional Lower Leg Support to the non-operative Leg Spar using an Accessory Clamp. Pad and secure the patient’s non-operative leg. Setup Complete The Hip Arthroscopy setup is now complete. For more information or questions about this setup or any setup, please refer to the Owner's Manual or contact Mizuho OSI for additional support.