Femur Lift and Femoral Hook Installation Femur Lift and Femoral Hook Installation Installing the Jack Mount Assembly To install the Jack Mount Assembly, slide it into the Mounting Slide on the underside of the tabletop. The safety latch will fall into the locked position. Femur Lift and Femoral Hook Installation Removing the Jack Mount Assembly To remove the Jack Mount Assembly, loosen the black knob to fully disengage the threads. Lift the safety latch to the unlocked position and pull forward on the Jack Mount Assembly. The Jack Mount Assembly should slide off freely without excessive force. Femur Lift and Femoral Hook Installation Femur Lift Assembly Junction Boxes The Hana Table uses a motorized Femur Lift Assembly to support and adjust the height of the Femoral Hooks for AATHA. The Femur Lift Assembly attaches to two Femur Lift Expansion Junction Boxes (left and right). Femur Lift and Femoral Hook Installation Connect Coiled Hook Motor Cables To connect the Coiled Hook Motor Cables, locate the red dot on the receptacle. Orient the plug so that the red dot aligns with the red dot on the receptacle. Push the plug into the receptacle until it clicks. Femur Lift and Femoral Hook Installation Mount the Femur Lift Mount the Femur Lift into the Jack Mount Assembly and tighten the Femur Lift Lock. Femur Lift and Femoral Hook Installation Femur Lift Foot Pedal A single Foot Pedal operates both left and right Femur Lifts. Plug the Foot Pedal into the port at the Foot-End of the table base. The flange should be flush or below the surface of the receptacle. Femur Lift and Femoral Hook Installation Femoral Hook and Femoral Hook Support The Femoral Hook and Femoral Hook Support provide support for the femur during Anterior Approach Total Hip Arthroplasty. The Femoral Hooks are imprinted with L and R to designate left and right. View Procedure Preparations